FireHog MOD-GEM4 Ambi Charging Handle with Gas Exhaust Mitigation | RED AR-10 LR.308 (UP-0721940)
100% Lifetime Satisfaction Warranty
All new for 2021 the MOD-GEM4 Gas Exhaust Mitigation Ambidextrous Charging handle for all AR-10/LR-308 upper receivers. The MOD-GEM4 Charging Handle is 3D machined from a solid block of aircraft grade 7075-T6 aluminum. Its fully independent ambidextrous design allows for seamless operation from either side of the weapon, it aims to alleviate some of the problems with MIL-SPEC Charging handles, without adding excessive weight. The Ambi levers are dual contoured similar to that of the charging handle of an M17, where not only the x-axis but also the y-axis receive radius cuts as well as groves for a grippy thumb placement. The handling surface of the lever is also grove cut, adding a textured grip aiding to the use when operating with gloves. The heightened rear lip of the MOD-GEM4 aids in mitigating gas blow back to the shooter when shooting with short barreled and suppressed weapon systems. All parts are then Type 3 Hardcoat anodized. The MOD-GEM4 releases cleanly and easily and is as smooth as butter. Looks great on any setup and without any extra bits, levers, pins or such sticking out.
The GEM-4 Technology Features exquisite gas exhaust technology system, Along with the raised rear lip, all excess gasses traveling towards the rear of the upper receiver will be diverted via the .136" Gas Exhaust Mitigation Port. No more burned up gunpowder residue to the face with every shot. Specifically designed to mitigate excess gas blowback due to suppressed rigs. All excess gas is ported to the right side on the charging handle and diverted away from the shooters face. Look no further for a high performance "Gas Busting" type of charging handle that will perform well under pressure and keep harmful gas ,dirt, and oil out of your face for a more pleasant shooting experience with much less shooters fatigue.
- Gas Exhaust Mitigation Technology
- Ideal for suppressed and SBR setups
- Tactical Ambi Charging Handle w/ Butterfly Latch
- Precision machined from rugged and lightweight 7075 T-6 aluminum.
- Hard coat type II anodized to prevent wearing of surface
- Anodized : RED
- Assembled in USA